|
TIMBER LIST
The following list of materials is approximate and intended for calculation of approximate costs. We offer no guarantees of accuracy.
The list is for all timber in the construction of hull, deck and interior, including building stocks, temporary bracing etc. Allowance has been made in the quantities for wastage of 20% on solid timber and 33% on plywood, with the exception of the building stocks and chipboard, which are net.
|
CHIPBOARD (for setting out bulkheads if building from offsets)
1,83x2,74m (6'x9') 16mm (5/8") - 1 sheet
MARINE PLYWOOD 1,22x2,44m (4'x8') (preferably Gaboon or Okoume plywood)
4.5mm (3/16") - 6 sheets (use 4mm if 4.5mm is not available)
6mm (1/4") - 4 sheets
9mm (3/8") - 20 sheets
12mm (1/2") - 6 sheets
SAWN PINE (for building stocks etc)
25X125mm (1"x5") (rails) - 18m
50x50mm (2"x2") (bulkhead legs) - 15m
75x75mm (3"x3") (posts) - 8m
CEDAR or similar, selected, free of knots, shakes fractures etc
12x22mm (1/2"x 7/8") (washboard slides) - 5m (17')
22x22mm (7/8"x7/8") (radius stringers, deck stringers, joinery cleats) - 89m (292')
22x22mm (7/8"x7/8") Triangular fillets (keel box, cockpit) - 16m (53')
22x32mm (7/8"x1 1/4") (bulkhead cleats) - 4m (14')
22x44mm (7/8"x1 3/4") (berth bearers, beams, hatch slides) - 19m (63')
22x64mm (7/8"x2 1/2") (sheer clamps, hatch frame) - 20m (66')
22x100mm (7/8"x4") (companion ladder) - 4m (14')
23x32mm (29/32"x1 1/4") (tangent stringers) - 34m (112')
32x32mm (1 1/4"x1 1/4") (side & bottom stringers) - 31m (102')
44x44mm (1 3/4"x1 3/4") Triangular fillet (foot braces) - 5m (17')
SAPELE MAHOGANY or similar dense hardwood
69x69mm (2 3/4"x2 3/4") (keel foil) - 17m (56')
RESIN & GLASS (for coatings and reinforced areas)
Epoxy resin (low viscosity 100% solids) - 50kg (110lb)
50mm (2") Wide woven tape - 70m (230')
75mm (3") Wide tape - 14m (46')
300g/sq.m (9oz/sq.yd) Woven roving - 2sq.m (22sq.ft)
450g/sq.m Biaxial fabric - 9sq.m (87sq.ft)
|